5/8″ (-10) DSM Turbo Oil Drain Kit- Xona, Garrett, EFR, PTE

$99.00

Full flow 5/8″ (-10 equivalent) oil drain kit for journal and ball bearing turbos. AN fittings and lines definitely work, but we’ve always preferred a simple clamped hose with fittings that are much closer to an actual 5/8″ ID than a comparable AN fitting. Allows future turbo removal by sliding the hose off instead of dealing with gaskets. We hope it makes things as easy for you as it has for us!

For larger journal bearing turbos that require a high volume of oil, such as Holset and Borg Warner S300/400, we recommend our larger 3/4″ oil drain kit. For most setups 5/8″ or -10 is plenty however, and our 5/8″ kit will flow better than most -10 AN kits to begin with.

*Turbo drain flange not compatible or intended for MHI bolt-on turbos, please see our MHI kit.

**Top mount configurations have an extra charge for the additional material/welds

Out of stock

Description

The turbo fitting has been slightly angled towards the pan fitting, giving it a more direct route while also allowing it to better clear the 1g front motor mount bracket for most standard placement/bottom mount turbo combinations- especially helpful for turbos with longer center section lengths such as Borg Warner EFR and PTE. The oil pan fitting is also angled up slightly to promote more oil drainage out of the line.

Heat sleeve/shielding is recommended near any exhaust components. For 1g/2g/GVR4/Evo1-3 with standard location turbo setups. Top mount oil drain kits available upon request.

Includes:

-5/8″ stainless turbo drain fitting, angled away from compressor cover and towards the oil pan fitting
-5/8″ stainless fitting that bolts to the factory DSM oil pan, angled up for better drainage
-12″ of 5/8″ high temp oil resistant push on hose (cut to length by user)
-Two stainless oil pan bolts with self sealing o-rings under the bolt heads
-Two stainless turbo bolts
-Two stainless hose clamps
* Does not include gaskets
*Not compatible/intended for MHI bolt-on turbos with a 1.5″ center to center turbo drain flange, please see our MHI oil drain kit)

Top mount configurations are $139 for the additional material/welds

To place an order, please fill out the contact form here.

After receiving the completed worksheet below, we will email an invoice over and ship within 1-2 business days after payment.

If you are interested in purchasing over five (5), we will contact you directly after submission of the form.

 

5/8″ (-10) DSM Turbo Oil Drain Kit- Xona, Garrett, EFR, PTE